Salamander-designs Synergy System SB303C/B Manuel d'utilisateur télécharger pdf

BEFORE YOU BEGIN:

• Unpack all parts before beginning and refer to the drawing below.

• Shelf pegs and door hinges must slide into the channels of the post in the correct order.

They cannot be removed individually without disassembling the whole unit.

SYNERGY 303

Instructions

Includes:

(1) SU30 - Synergy Base Unit

(1) SS30 - 30” Side Panel Set

(1) SD30 - 30” Doors

Limited Warranty

For five full years Salamander Designs Ltd. will repair or replace, at our option, any product defective in materials or craftsmanship. Salamander Designs Ltd. will not be responsible for any damage to or destruction of other equipment consequential

to our equipment failure. Defective product must be given Return Authorization and is to be returned to the factory prepaid, in the original carton and packing material. Any damage incurred in a shipment not in original packaging shall be the

responsibility of the owner. Warranty repairs will be returned prepaid, via UPS within the continental U.S.A. only. Salamander Designs Ltd. • 800-535-5659 • www.SalamanderDesigns.com

Leveler Foot

Hex Nut

Washer

B. Connect Post

Screw foot with metal washer

through bottom shelf and

onto the end of an extruded

post. Hand tighten fully and

use wrench on hex nut to tighten

nut onto underside of shelf.

A. Square Post

Square the post to the bottom shelf.

Connect Posts to Bottom Shelf

WARNING: Tighten by screwing the leveler foot NOT the post.

Add Shelf Pegs & Door Hinges

B. Insert Hinges, Shelf Pegs & Heavy Duty Bracket

Note: The door can be either left or right side opening. Select a side to open door.

1. Hold door above the post and slide the

bottom

hinge plate through the post channel.

2. Insert shelf pegs and heavy duty bracket.

3. Slide top hinge plate through.

4. Gently tighten all remaining pegs with the

hex key to desired position.

A. Group Shelf Pegs

There are two varieties of shelf pegs (A and B).

They are designed to cradle the shelf in place.

Refer to drawing.

Top Shelf (1)

Adjustable Shelf (3)

Bottom Shelf (1)

Joint Connector Bolt 300-540 (4)

Foot & Nut P-300-350 (4)

Door (1)

Aluminum Post (4)

Sides (2)

Washer 300-470 (4)

Shelf Peg

PHK-370 Right (4)

PHK-380 Left (4)

Heavy Duty Bracket (2)

Rubber Tabs

1 2

Résumé du contenu

Page 1 - SYNERGY 303

BEFORE YOU BEGIN:• Unpack all parts before beginning and refer to the drawing below.• Shelf pegs and door hinges must slide into the channels of the p

Page 2 - Attach Door

A. Insert Hardware Combine the 1” threaded studs with the flat nuts. Slide hardware into rear channel.A. Attach Hinges to Door Frame

Commentaires sur ces manuels

Pas de commentaire

Salamander-designs Synergy System SB303C/B Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Meubles Salamander-designs Synergy System SB303C/B. Salamander Designs Synergy System SB303C/B User Manual Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Produits connexes et manuels pour Meubles Salamander-designs Synergy System SB303C/B